Hi
From the README file in ivtv source:
NOTE 3: The names of the inputs have changed to correspond with the names
as are used by the video4linux subsystem. This means that MythTV users have
to setup their inputs again. In particular 'Tuner 0' is now 'Tuner 1'.
as are used by the video4linux subsystem. This means that MythTV users have
to setup their inputs again. In particular 'Tuner 0' is now 'Tuner 1'.
You must use Tuner 1 not Tuner 0 in mythtv-setup.
Harald
On 6/12/06, Ian Campbell <[EMAIL PROTECTED]> wrote:
On Sun, 2006-06-11 at 08:07 -0500, David Pettit wrote:
> Okay, I need some help determining where the source of my current problem
> lies. I can capture video just fine using 'cat /dev/video0 >capture.mpg',
> however when I start mythbackend I get the error message three times:
>
> cx25840 3-0044: 0x0000 is not a valid video input!
>
> Also, when I run mythtv-setup, on the page where it says "connect source to
> input" under video source it says "(None)" and there are no other options.
> If I try to "Scan for Channels", it says "Failed to open the card".
>
> Is this a MythTV problem or an IVTV problem?
If you can capture fine with 'cat' then I'd suspect mythtv. Are you
using the packages from debian-multimedia.org ?
Does your mythtv user have permission to read/write the ivtv device?
Ian.
--
Ian Campbell
There is nothing new except what has been forgotten.
-- Marie Antoinette
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.3 (GNU/Linux)
iD8DBQBEjQTLM0+0qS9rzVkRAhavAJ9EUo5G57zw+OAzn5LcT33TGfBiCgCdGZCO
fToWG87Q4lcjD0kX3sOdIbQ=
=CEFi
-----END PGP SIGNATURE-----
_______________________________________________
ivtv-users mailing list
[email protected]
http://ivtvdriver.org/mailman/listinfo/ivtv-users
_______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
