I have recently installed a second pvr-150 in my myth system and the second tuner will NOT autodetect. I am running Debian Sarge 2.6.17 kernel with ivtv 0.7.0. I have upgraded and recompiled everything including the firmware per your website. In addition to not autodetecting it will not let me set the tuner via an options clause in the modprobe, providing the option in the ivtv file in modprobe.d, or the two distro specific config files.
Here is my dmesg output: ivtv: ==================== START INIT IVTV ==================== ivtv: version 0.7.0 (tagged release) loading ivtv: Linux version: 2.6.17-chw-8 SMP preempt mod_unload 586 gcc-3.4 ivtv: In case of problems please include the debug info between ivtv: the START INIT IVTV and END INIT IVTV lines, along with ivtv: any module options, when mailing the ivtv-users mailinglist. ivtv0: Autodetected Hauppauge WinTV PVR-150 card (cx23416 based) ACPI: PCI Interrupt 0000:00:0a.0[A] -> GSI 18 (level, low) -> IRQ 22 tuner 0-0061: chip found @ 0xc2 (ivtv i2c driver #0) cx25840 0-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #0) cx25840 0-0044: loaded v4l-cx25840.fw firmware (16382 bytes) wm8775 0-001b: chip found @ 0x36 (ivtv i2c driver #0) tveeprom 0-0050: Hauppauge model 26052, rev C599, serial# 8805504 tveeprom 0-0050: tuner model is TCL 2002N 5H (idx 99, type 50) tveeprom 0-0050: TV standards NTSC(M) (eeprom 0x08) tveeprom 0-0050: audio processor is CX25843 (idx 37) tveeprom 0-0050: decoder processor is CX25843 (idx 30) tveeprom 0-0050: has no radio, has IR remote eth0: no IPv6 routers present eth1: no IPv6 routers present ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes) ivtv0: Encoder revision: 0x02050032 ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total) ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total) ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total) tuner 0-0061: type set to 50 (TCL 2002N) ivtv0: Initialized Hauppauge WinTV PVR-150, card #0 ivtv: ====================== NEXT CARD ====================== ivtv1: Autodetected Hauppauge WinTV PVR-150 card (cx23416 based) ACPI: PCI Interrupt 0000:00:0c.0[A] -> GSI 16 (level, low) -> IRQ 17 tuner 1-0061: chip found @ 0xc2 (ivtv i2c driver #1) cx25840 1-0044: cx25841-23 found @ 0x88 (ivtv i2c driver #1) cx25840 1-0044: loaded v4l-cx25840.fw firmware (16382 bytes) wm8775 1-001b: chip found @ 0x36 (ivtv i2c driver #1) tveeprom 1-0050: Hauppauge model 26132, rev F0B2, serial# 9399761 tveeprom 1-0050: tuner model is TCL M2523_5N_E (idx 112, type 4) tveeprom 1-0050: TV standards NTSC(M) (eeprom 0x08) tveeprom 1-0050: audio processor is CX25841 (idx 35) tveeprom 1-0050: decoder processor is CX25841 (idx 28) tveeprom 1-0050: has no radio, has IR remote ivtv1: loaded v4l-cx2341x-enc.fw firmware (262144 bytes) ivtv1: Encoder revision: 0x02050032 ivtv1: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) ivtv1: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total) ivtv1: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total) ivtv1: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total) tuner 1-0061: tuner type not set tuner 1-0061: tuner type not set ivtv1: Initialized Hauppauge WinTV PVR-150, card #1 ivtv: ==================== END INIT IVTV ==================== Oddly enough this output was generated with the following /etc/modprobe.d/ivtv file in place alias char-major-81 videodev alias char-major-81-0 ivtv alias char-major-81-1 ivtv options ivtv tuner=50 This is per your website at http://www.ivtvdriver.org/index.php/Howto#Module_options I have tried the following tuner numbers with no success (per many different websites): 0,4,39,43,47,49,50 I even upgraded my knoppmyth distro to R5D1 which was released a couple weeks ago. With this distro there are two other possible configuration files. One is the /etc/mythtv/modules/ivtv1 (for the second tuner) to which I added the same options line as the /etc/modprobe.d/ivtv file (supposed to be the same syntax). Then there is the /etc/sysconfig/ivtv/cfg-1 (again the 1 for the second card) and uncommented out the ivtv_tuner line. I also made sure all these files contained the same values at all times. Of course trying for each of the above listed tuner values. I also have made sure I have not used Mythtv to test the tuner. I have used the command line tools as per your troubleshooting guide. I have seen on the list that the tuner type of 4 with an idx of 112 have been successfully configured and are in use I do not understand why my system refuses to recognize the second tuner automatically. I also do not understand why it refuses to be force configured as many on the list have had to do. Andre _______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
