Oh thank you for your reply!
Unfortunately yes, I have selected an input, and I'm confident I
have the correct input as I receive the "Signal Detected" message when I
set the channel. Despite that, my test.mpg is still 0kb.
Where can I turn next?
Thanks again for your reply. Without any obvious error
messages, I am really stuck here :(
j
On Fri, Nov 24, 2006 at 09:56:21AM -0500, Stephane Gaucher wrote:
> Did you select a input.
> You will have to use a command like v4l!??! sorry about the completion. It's a
> memory call ;))
>
> Take a look around this.
>
>
> >
> > Well, I managed to find the missing kernel options in my new
> > kernel, and now the drivers load without any error messages at all!!
> >
> > The only problem is that I still cannot get anything when I cat
> > /dev/video0 > test.mpg. File size remains zero no matter what I try.
> >
> > I've tried using ivtv-tune -c3 to change the channel, and it
> > gives me a signal detected message, but still a zero bit file size.
> >
> > xawtv's hardware scan (xawtv -hwscan) finds the PVR150 and says
> > /dev/video0 is "OK" but display nothing but a blank sceen when I tell
> > it to display device /dev/video0
> >
> > As the /var/log/messages and /var/log/syslog are all clear of
> > errors, I'm not sure what to do next :(
> >
> > Please help.
> >
> > Greatly appreciated.
> >
> > j
_______________________________________________
ivtv-users mailing list
[email protected]
http://ivtvdriver.org/mailman/listinfo/ivtv-users
