Hi!

I'm using Gentoo with kernel 2.6.19 (r5) with a Hauppauge PVR-350.
I've already found out, that I have this special tuner (type 38), so  
I added "options ivtv tuner=38" to my "/etc/modules.d/ivtv". There  
are no errors when modprobing ivtv and the antenna cable is working  
fine (tested it with a tv-set).

The card is being detected correctly and listed in lspci:

------------------------------------------------------------------------ 
------------------------------------
router ~ # lspci -v
(...)
00:0a.0 Multimedia video controller: Internext Compression Inc iTVC15  
MPEG-2 Encoder (rev 01)
         Subsystem: Hauppauge computer works Inc. WinTV PVR-350
         Flags: bus master, medium devsel, latency 64, IRQ 4
         Memory at c8000000 (32-bit, prefetchable) [size=64M]
         Capabilities: [44] Power Management version 2

------------------------------------------------------------------------ 
------------------------------------
router ~ # dmesg
(...)
Linux video capture interface: v2.00
ivtv:  ==================== START INIT IVTV ====================
ivtv:  version 0.10.1 (tagged release) loading
ivtv:  Linux version: 2.6.19-gentoo-r5 mod_unload K7 REGPARM
ivtv:  In case of problems please include the debug info between
ivtv:  the START INIT IVTV and END INIT IVTV lines, along with
ivtv:  any module options, when mailing the ivtv-users mailinglist.
ivtv0: Autodetected Hauppauge card (cx23415 based)
ACPI: PCI Interrupt 0000:00:0a.0[A] -> Link [LNKC] -> GSI 4 (level,  
low) -> IRQ 4
ivtv0: loaded v4l-cx2341x-enc.fw firmware (376836 bytes)
ivtv0: loaded v4l-cx2341x-dec.fw firmware (262144 bytes)
ivtv0: Encoder revision: 0x02060039
ivtv0: Decoder revision: 0x02020023
tuner 0-0043: chip found @ 0x86 (ivtv i2c driver #0)
tda9887 0-0043: tda988[5/6/7] found @ 0x43 (tuner)
tuner 0-0061: chip found @ 0xc2 (ivtv i2c driver #0)
saa7115 0-0021: saa7115 found (1f7115d0e100000) @ 0x42 (ivtv i2c  
driver #0)
saa7127 0-0044: saa7129 found @ 0x88 (ivtv i2c driver #0)
msp3400 0-0040: MSP4418G-B3 found @ 0x80 (ivtv i2c driver #0)
msp3400 0-0040: MSP4418G-B3 supports nicam and radio, mode is  
autodetect and autoselect
tveeprom 0-0050: Hauppauge model 48139, rev K2B7, serial# 9888104
tveeprom 0-0050: tuner model is Philips FM1216ME MK5 (idx 117, type 38)
tveeprom 0-0050: TV standards PAL(B/G) PAL(I) SECAM(L/L') PAL(D/D1/K)  
(eeprom 0x74)
tveeprom 0-0050: audio processor is MSP4418 (idx 25)
tveeprom 0-0050: decoder processor is SAA7115 (idx 19)
tveeprom 0-0050: has radio, has IR remote
ivtv0: Autodetected Hauppauge WinTV PVR-350
ivtv0: Registered device video0 for encoder MPEG (4 MB)
ivtv0: Registered device video32 for encoder YUV (2 MB)
ivtv0: Registered device vbi0 for encoder VBI (1 MB)
ivtv0: Registered device video24 for encoder PCM audio (1 MB)
ivtv0: Registered device radio0 for encoder radio
ivtv0: Registered device video16 for decoder MPEG (1 MB)
ivtv0: Registered device vbi8 for decoder VBI (1 MB)
ivtv0: Registered device vbi16 for decoder VOUT
ivtv0: Registered device video48 for decoder YUV (1 MB)
ivtv0: loaded v4l-cx2341x-init.mpg firmware (155648 bytes)
tuner 0-0061: type set to 38 (Philips PAL/SECAM multi (FM1216ME MK3))
ivtv0: Initialized Hauppauge WinTV PVR-350, card #0
ivtv:  ====================  END INIT IVTV  ====================
ivtv0: DMA TIMEOUT 00000001 0
ivtv0: DMA TIMEOUT 00000001 0
ivtv0: DMA TIMEOUT 00000001 0

------------------------------------------------------------------------ 
------------------------------------

Testing the card:
------------------------------------------------------------------------ 
------------------------------------
router ~ # ivtv-tune -cE7
/dev/video0: 189.250 MHz  (Signal Detected)

router ~ # cat /dev/video0 > test.mpg

router ~ # du test.mpg
0       test.mpg
------------------------------------------------------------------------ 
------------------------------------
ivtv-tune says "Signal Detected" but as you can see, the file  
test.mpg remains empty, no matter how long I let the cat-stuff running.


Dunno if it helps, but here is part of the mythtvbackend-log:
------------------------------------------------------------------------ 
------------------------------------
2007-05-05 18:28:21.714 MPEGRec(/dev/video0) Error: select timeout -  
ivtv driver has stopped respondin
g
2007-05-05 18:28:22.434 RingBuf(/mnt/recordings/ 
2_20070505182815.mpg): Invalid file (fd -1) when openi
ng '/mnt/recordings/2_20070505182815.mpg'.
2007-05-05 18:28:22.454 MythSocket(81b8538:-1): writeStringList:  
Error, socket went unconnected.
2007-05-05 18:28:24.822 Expiring  from Sat May 5 18:26:46 2007, 0  
MBytes, forced expire (LiveTV record
ing)
------------------------------------------------------------------------ 
------------------------------------

My mainboard is a ASRock K7S41GX with this components:
------------------------------------------------------------------------ 
------------------------------------
00:00.0 Host bridge: Silicon Integrated Systems [SiS] 741/741GX/M741  
Host (rev 03)
00:01.0 PCI bridge: Silicon Integrated Systems [SiS] SiS AGP Port  
(virtual PCI-to-PCI bridge)
00:02.0 ISA bridge: Silicon Integrated Systems [SiS] SiS963 [MuTIOL  
Media IO] (rev 25)
00:02.1 SMBus: Silicon Integrated Systems [SiS] SiS961/2 SMBus  
Controller
00:02.5 IDE interface: Silicon Integrated Systems [SiS] 5513 [IDE]
00:03.0 USB Controller: Silicon Integrated Systems [SiS] USB 1.0  
Controller (rev 0f)
00:03.1 USB Controller: Silicon Integrated Systems [SiS] USB 1.0  
Controller (rev 0f)
00:03.2 USB Controller: Silicon Integrated Systems [SiS] USB 2.0  
Controller
00:04.0 Ethernet controller: Silicon Integrated Systems [SiS] SiS900  
PCI Fast Ethernet (rev 90)
00:09.0 Ethernet controller: Realtek Semiconductor Co., Ltd.  
RTL-8139/8139C/8139C+ (rev 10)
00:0a.0 Multimedia video controller: Internext Compression Inc iTVC15  
MPEG-2 Encoder (rev 01)
01:00.0 VGA compatible controller: Silicon Integrated Systems [SiS]  
661/741/760 PCI/AGP or 662/761Gx PCIE VGA Display Adapter
------------------------------------------------------------------------ 
------------------------------------

Would be great, if someone could help me ;)

Thanks,
Fabian










_______________________________________________
ivtv-users mailing list
[email protected]
http://ivtvdriver.org/mailman/listinfo/ivtv-users

Reply via email to