I'm having issues with my PVR-150 card. All the modules seem to load and /dev/video0 is created. Running ivtv-tune doesn't give errors. But when I try to "cat /dev/video0", I get nothing, no errors, just wait til I hit ^C to kill it.
In dmesg, I get this when I insert the ivtv module: tveeprom 0-0050: Huh, no eeprom present (err=-121)? tveeprom 0-0050: Encountered bad packet header [44]. Corrupt or not a Hauppauge eeprom. I've tried adding "newi2c=1" and that does nothing to change the symptoms. I'm using ivtv version 1.0.3 on gentoo kernel version 2.6.23 Here is a full dump of what seems to be the relevant part of dmesg: Linux video capture interface: v2.00 ivtv: Start initialization, version 1.0.0 ivtv0: Initializing card #0 ivtv0: Autodetected Hauppauge card (cx23416 based) PCI: Enabling device 0000:00:0d.0 (0014 -> 0016) ACPI: PCI Interrupt 0000:00:0d.0[A] -> Link [LNKD] -> GSI 4 (level, low) -> IRQ 4 ivtv0: Unreasonably low latency timer, setting to 64 (was 32) ivtv0: Loaded v4l-cx2341x-enc.fw firmware (376836 bytes) ivtv0: Encoder revision: 0x02060039 tveeprom 0-0050: Huh, no eeprom present (err=-121)? tveeprom 0-0050: Encountered bad packet header [44]. Corrupt or not a Hauppauge eeprom. ivtv0: Invalid EEPROM ivtv0: i2c hardware 0x00000001 (cx2584x) not found for command 0xc008561c ivtv0: i2c addr 0x44 not found for command 0x4008646f ivtv0: i2c hardware 0x00000020 (wm8775) not found for command 0x4008646d ivtv0: i2c hardware 0x00000001 (cx2584x) not found for command 0x4008646d ivtv0: i2c hardware 0x00000001 (cx2584x) not found for command 0xc008561c ivtv0: i2c hardware 0x00000001 (cx2584x) not found for command 0xc008561c ivtv0: i2c hardware 0x00000001 (cx2584x) not found for command 0xc008561c ivtv0: Registered device video0 for encoder MPEG (4 MB) ivtv0: Registered device video32 for encoder YUV (2 MB) ivtv0: Registered device vbi0 for encoder VBI (1 MB) ivtv0: Registered device video24 for encoder PCM audio (1 MB) ivtv0: Registered device radio0 for encoder radio ivtv0: Initialized card #0: Hauppauge WinTV PVR-150 ivtv: End initialization ACPI: PCI Interrupt Link [LNKA] enabled at IRQ 11 ACPI: PCI Interrupt 0000:01:00.0[A] -> Link [LNKA] -> GSI 11 (level, low) -> IRQ 11 Help!
_______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
