On Mon, 2008-05-12 at 12:01 -0700, Michael wrote: > > > cx18-0: Could not start the CPU > > > > This is a problem for you. > > > > You can try this: > > > > 1. Find the "#if 0" on line 347 of > > linux/drivers/media/video/cx18/cx18-firmware.c in the function > > cx18_firmware_init() and change it to "#if 1". > > > > 2. recompile and reinstall the cx18 driver > > > > 3. unload and reload the newly built cx18 module > > > > Well, after I recompiled everything, heres the dmesg. Most of the previous > errors are gone, however I can't seem to find any program that can play it. > (And might I add, there are very few TV viewing programs that I've found. > Very few. > > cx18: Start initialization, version 1.0.0 > cx18-0: Initializing card #0 > cx18-0: Autodetected Hauppauge card > cx18-0: cx23418 revision 01010000 (B) > tveeprom 0-0050: Encountered bad packet header [00]. Corrupt or not a > Hauppauge eeprom. > cx18-0: Invalid EEPROM
Nope. Your EEPROM invalid problem came back. I believe this will be a problem for you (the driver can't tell what analog TV tuner device you have without reading the EEPROM). Please try modprobing the tveeprom module with debug=1 in advance of modprobing the cx18 driver. > cx18-0: DVB & VBI are not yet supported > cs5345 0-004c: chip found @ 0x98 (cx18 i2c driver #0-0) > cx18-0: Disabled encoder IDX device > videodev: "" has no release callback. Please fix your driver for proper sysfs > support, see http://lwn.net/Articles/36850/ > cx18-0: Registered device video0 for encoder MPEG (2 MB) > DVB: registering new adapter (cx18). > MXL5005S: Attached at address 0x63 > DVB: registering frontend 0 (Samsung S5H1409 QAM/8VSB Frontend)... > cx18-0: DVB Frontend registered > videodev: "" has no release callback. Please fix your driver for proper sysfs > support, see http://lwn.net/Articles/36850/ > cx18-0: Registered device video32 for encoder YUV (2 MB) > videodev: "" has no release callback. Please fix your driver for proper sysfs > support, see http://lwn.net/Articles/36850/ > cx18-0: Registered device video24 for encoder PCM audio (1 MB) > videodev: "" has no release callback. Please fix your driver for proper sysfs > support, see http://lwn.net/Articles/36850/ > cx18-0: Registered device radio-64 for encoder radio > cx18-0: loaded v4l-cx23418-apu.fw firmware V00120000 (141200 bytes) > cx18-0: loaded v4l-cx23418-cpu.fw firmware (174716 bytes) > cx18-0: loaded v4l-cx23418-dig.fw firmware (16382 bytes) > cx18-0: Initialized card #0: Hauppauge HVR-1600 > cx18: End initialization With the latest driver, it's normal to see the firmware loaded *twice* at module load (to overcome a hardware bug). Here it was only loaded once. -Andy > And unlike in the past, it was only run once, not the 3 times it was in the > past. > > Thanks! > _______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
