Darren, You were absolutely correct. Re-seating the card solved the problem. Many thanks for the quick response!
Peter On 12 March 2010 22:30, Darren <[email protected]> wrote: > I had a similar issue, what I did was remove the card and reinsert it > (reseating) and it seemed to work fine. > > On Fri, Mar 12, 2010 at 8:49 PM, Peter Klimas <[email protected]> > wrote: >> >> Hi, I have a Hauppage WinTV-HVR-1600 (Digital + Analog tuners with IR >> receiver). The card appeared >> to work fine until my last kernel update (upgraded to 2.6.32.9). Since >> then, I have also >> upgraded the v4l-dvb modules to v4l-dvb-e50bb36f881c. Unfortunately, >> still no success. >> >> Now I only get the following output during boot: >> cx18: Start initialization, version 1.4.0 >> cx18: End initialization >> >> After some digging, I found that >> http://pci-ids.ucw.cz/read/PC/0070/7444 lists the >> Hauppage 1600 as: >> Hauppauge's HVR-1600 board, PCI ID 14f1:5b7a, Subsystem 0070:7444 >> >> Unfortunately, this is NOT what my card returns, output from my lspci >> is below and clearly >> shows the ID as 597a NOT 5b7a. Could this be why the card isn't >> working anymore or >> should I be looking for the problem somewhere else (hardware failure >> etc.)? >> >> Any help would be appreciated, >> Many thanks, >> Peter >> >> >> lspci verbose output below >> >> ---------------------------------------------------------------------------------- >> 00:0a.0 Multimedia video controller: Conexant Systems, Inc. Device 597a >> Subsystem: Hauppauge computer works Inc. Device 7444 >> Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- >> Stepping- SERR+ FastB2B- DisINTx- >> Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=fast >TAbort- >> <TAbort- <MAbort- >SERR- <PERR+ INTx- >> Latency: 32 (500ns min, 50000ns max), Cache Line Size: 32 bytes >> Interrupt: pin A routed to IRQ 10 >> Region 0: Memory at c8000000 (32-bit, non-prefetchable) [size=64M] >> Capabilities: [44] Vital Product Data >> pcilib: sysfs_read_vpd: read failed: Connection timed out >> Not readable >> Capabilities: [4c] Power Management version 2 >> Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA >> PME(D0-,D1-,D2-,D3hot-,D3cold-) >> Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME- >> >> _______________________________________________ >> ivtv-users mailing list >> [email protected] >> http://ivtvdriver.org/mailman/listinfo/ivtv-users > > > > -- > Darren Blaber > > _______________________________________________ > ivtv-users mailing list > [email protected] > http://ivtvdriver.org/mailman/listinfo/ivtv-users > _______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
