Andy Walls wrote:
On Sat, 2010-05-22 at 11:17 -0400, J McBride wrote:
I have attempted to get a Hauppauge HTV-1600 card working in
SimpyMepis. I have generally followed the steps in the following
how-to guides:
http://www.linuxtv.org/wiki/index.php/How_to_Obtain,_Build_and_Install_V4L-DVB_Device_Drivers
and
http://ivtvdriver.org/index.php/Howto:Debian
I had to run "make config" and not configure the FireTV due to a
compilation error, then all seemed to work well until the command:
#modprobe cx18
which resulted in the error:
FATAL: Error inserting cx18
(/lib/modules/2.6.32-1-mepis64-smp/kernel/drivers/media/video/cx18/cx18.ko):
Unknown symbol in module, or unknown parameter (see dmesg)
Then I did:
dmesg |grep cx18
cx18: Unknown symbol ir_codes_hauppauge_new_table
So, I am at my limit here. I cannot find any similar errors through
google. Any suggestions on how I get this to work?
Please report this to the [email protected] list. There has
been recent IR churn that you're running into.
I'll try to respond later today, but life's busy. Odd's are there are
some new IR modeuls that didn't get built.
Regards,
Andy
_______________________________________________
ivtv-users mailing list
[email protected]
http://ivtvdriver.org/mailman/listinfo/ivtv-users
If you're impatient, you might want to try an older changeset. I've been using
this one from 12/7/09 and have been happy with it:
http://linuxtv.org/hg/v4l-dvb/archive/065f9e34e07b.tar.bz2
HTH,
Helen
_______________________________________________
ivtv-users mailing list
[email protected]
http://ivtvdriver.org/mailman/listinfo/ivtv-users
