Hi, I am using ivtv-0.3.2k with a pvr-150 on myth and it took a lot of
tinkering, but its mostly working now. Some audio squeal maybe, but
I'm not worried about that for the moment.

I have not been able to get lirc to work with the supplied remote yet.
 I tried the lirc rpms from atrpms, and everything would look like it
was working, irw would connect to lircd, but i would not see any
output from irw.  I am using the lircd.conf from
http://wilsonet.com/mythtv/lircd-g3.conf.txt

I got lirc-0.7.1pre2 to see if that would work,  and basically the
same thing.  irw will connect, but no output.

Any suggestions?  

lsmod shows:
bttv                  148753  0
video_buf              21829  1 bttv
v4l2_common             5825  1 bttv
btcx_risc               4681  1 bttv
lirc_i2c                7172  0
lirc_dev               11844  1 lirc_i2c
wm8775                  9756  0
cx25840               120620  0
tuner                  19244  0
tveeprom               11956  0
ivtv                  808260  2
i2c_algo_bit            8393  2 bttv,ivtv
videodev                9537  4 bttv,ivtv


dmesg shows:

ivtv: ==================== START INIT IVTV ====================
ivtv: version 0.3.2 (k) loading
ivtv: Linux version: 2.6.10-1.770_FC3 686 REGPARM 4KSTACKS gcc-3.4
ivtv: In case of problems please include the debug info
ivtv: between the START INIT IVTV and END INIT IVTV lines when
ivtv: mailing the ivtv-devel mailinglist.
ivtv: Autodetected WinTV PVR 150 card
ivtv: Found an iTVC16 based chip
ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 10
PCI: setting IRQ 10 as level-triggered
ACPI: PCI interrupt 0000:00:09.0[A] -> GSI 10 (level, low) -> IRQ 10
ivtv: Unreasonably low latency timer, setting to 64 (was 32)
ivtv: VIA PCI device: 0x0305 vendor: 0x1106
tveeprom: Hauppauge: model = 26052, rev = C185, serial# = 7579491
tveeprom: tuner = TCL 2002N 6A (idx = 85, type = 50)
tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000)
tveeprom: audio_processor = MSP3410D (type = 5)
ivtv: i2c attach [client=tveeprom[0],ok]
ivtv: Tuner Type 50, Tuner formats 0x00001000, Radio: yes, Model
0x008d1615, Revision0x00000000
ivtv: NTSC tuner detected
ivtv: Radio detected
tuner: Ignoring new-style parameters in presence of obsolete ones
tuner: chip found at addr 0xc2 i2c-bus ivtv i2c driver #0
ivtv: i2c attach [client=(tuner unset),ok]
cx25840: Ignoring new-style parameters in presence of obsolete ones
cx25840: Unable to open FW file '/lib/modules/HcwMakoA.ROM'.
cx25840: Failed to load any FW image file
ivtv: i2c attach [client=cx25840[0],ok]
ivtv: i2c attach [client=wm8775[0],ok]
ivtv: Encoder revision: 0x02040024
ivtv: Encoder Firmware may be buggy, use version 0x02040011
ivtv: Configuring WinTV PVR 150 card with 5 streams
ivtv: Registered v4l2 device, streamtype 0 minor 0
ivtv: Create DMA stream 0 using 1024 16384 byte buffers  0 kbytes total
ivtv: Allocate DMA stream 0 using 1024 16384 byte buffers  16777216 kbytes total
ivtv: Registered v4l2 device, streamtype 1 minor 32
ivtv: Create DMA stream 1
ivtv: Allocate DMA stream 1
ivtv: Registered v4l2 device, streamtype 2 minor 224
ivtv: Create stream 2 using 40 52224 byte buffers  0 kbytes total
ivtv: Allocate stream 2 using 40 52224 byte buffers  2097152 kbytes total
ivtv: Registered v4l2 device, streamtype 3 minor 24
ivtv: Create DMA stream 3 using 455 4608 byte buffers  0 kbytes total
ivtv: Allocate DMA stream 3 using 455 4608 byte buffers  2097152 kbytes total
ivtv: Registered v4l2 device, streamtype 4 minor 64
ivtv: Create stream 4
ivtv: Allocate stream 4
ivtv: Setting Tuner 50
tuner: type set to 50 (TCL 2002N) by ivtv i2c driver #0
ivtv: Switching standard to NTSC.
ivtv: Initialized WinTV PVR 150, card #0
ivtv: ====================  END INIT IVTV  ====================
lirc_dev: no version for "struct_module" found: kernel tainted.
lirc_dev: IR Remote Control driver registered, at major 61
ivtv: ivtv_enc_thread: pid = 4429, itv = 0xf0cf3ca0
bttv: driver version 0.9.15 loaded
bttv: using 8 buffers with 2080k (520 pages) each for capture
cx25840: Decoder set size 720x480 (from 720x487) -> scale  0x65529, filter 0


Does "kernel tainted" mean anything I should be concerned about?

Also, mode2 will not open /dev/lircd and gives the error:
mode2: error opening /dev/lircd
mode2: No such device or address

I don't know if that is important.

Thanks for any input!  Let me know if I left out any necessary details.


-------------------------------------------------------
This SF.net email is sponsored by: 2005 Windows Mobile Application Contest
Submit applications for Windows Mobile(tm)-based Pocket PCs or Smartphones
for the chance to win $25,000 and application distribution. Enter today at
http://ads.osdn.com/?ad_id=6882&alloc_id=15148&op=click
_______________________________________________
Ivtv-users mailing list
Ivtv-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/ivtv-users

Reply via email to