Hi Jan Willem,
Jan Willem wrote: > I have copy your code (the following) into my Jal Edit and i have > compile it: > ====================================================== > :020000040000FA > :100000000508A200073099008316051083122214F8 > :100010002208850083120313FB30A000C630A10024 > :100020000A128A11A10B10280A128A11A00B0E289D > :10003000000022102208850083120313FB30A00069 > :10004000C630A1000A128A11A10B22280A128A11B5 > :08005000A00B20280000062887 > :02400E00F4318B > :00000001FF > ====================================================== A compare shows that your hex file is exactly the same as mine (not surprisingly!). Nevertheless I loaded it into my 12F629 and the led on pin_A0 blinks as expected. > When i load this .hex file into my 12F629 chip, pin A0 is not going > high and low. > You have tested your code (your .hex file) in your 12F629 chip en > pinA0 is going high and low OK. > Can you give me, or can you compare what the different is between your > and my .hex file? The only reason that your code is working OK at your > chip and not at my chip, is that your .hex file is not the same as > my .hex file. There must be another reason since the hex files are identical. > PinA0 of my chip is OK, because when i load the .hex file of Wouter, > pinA0 is going high and low. I assume you used b675i-2.hex, I couldn't find any for the 12F629. When I load this file into my 12F629 the led on A0 blinks as expected! > I am very interesting what your .hex file is. I'm afraid the problem is not with the hex file, and I have run out of ideas what it could be! Regards, Rob. -- Rob Hamerling, Vianen, NL (http://www.robh.nl/) --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "jallib" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/jallib?hl=en -~----------~----~----~----~------~----~------~--~---
