You have it hooked up like this and if you didn't care post the configure part of your code
On Mon, Sep 27, 2010 at 9:51 PM, Burt Ratliff <[email protected]> wrote: > USBEN: USB Module Enable bit(1) > 1 = USB module and supporting circuitry enabled (device attached) > 0 = USB module and supporting circuitry disabled (device detached) > bit 2 RESUME: Resume Signaling Enable bit > 1 = Resume signaling activated > 0 = Resume signaling disabled > bit 1 SUSPND: Suspend USB bit > 1 = USB module and supporting circuitry in Power Conserve mode, SIE clock > inactive > 0 = USB module and supporting circuitry in normal operation, SIE clock > clocked at the configured rate > bit 0 Unimplemented: Read as ‘0’ > Note 1: This bit cannot be set if the USB module does not have an > appropriate clock source. > > > On Tue, Sep 28, 2010 at 12:28 AM, mattschinkel > <[email protected]>wrote: > >> I can't get USB to work with either internal or external OSC. I get no >> response from my PC. >> >> VCAP is 10uf, and VUSB goes direct to 3.3v. >> >> Matt. >> >> On Sep 27, 10:46 pm, William <[email protected]> wrote: >> > Greetings Matt, >> > >> > On Sep 27, 8:06 am, mattschinkel <[email protected]> wrote: >> > >> > >> > >> > > Can I use Internal Oscillator for USB? What settings can I use? >> > >> > I'm concerned that the internal oscillator may not meet the USB specs, >> > so I'd advise a crystal oscillator if you want to connect to your PC. >> > >> > William >> >> -- >> You received this message because you are subscribed to the Google Groups >> "jallib" group. >> To post to this group, send email to [email protected]. >> To unsubscribe from this group, send email to >> [email protected]<jallib%[email protected]> >> . >> For more options, visit this group at >> http://groups.google.com/group/jallib?hl=en. >> >> > -- You received this message because you are subscribed to the Google Groups "jallib" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/jallib?hl=en.
<<attachment: v_usb.PNG>>
