Hi Matt, Thanks for the help :-) The protocol is relatively the same. The 24LC1025 has an internal addressing boundary limitation that is divided into two segments of 512K bits. Block select bit ‘B0’ in the control byte is used to control access to each segment. I just added a bit sized argument to the read and write procedures to allow that bit to be set to allow access to either segment. Please have a look if you like to make sure I didn't screw up anything :-) Also, I only had a 16F747 running on a 4 MHz resonator to test it, so that's how I have the sample code set up. It ran fine on the 16F747. I don't see any problems running it on the 16F877a at 20MHz ( their pinouts are the same ) as most of the sample code, but I have not tested it.
As for SVN, I did try to upload it earlier. I didn't have access yet. I'll check back in a bit and get the code up asap. Thanks again! -Brain On Oct 20, 9:15 pm, mattschinkel <[email protected]> wrote: > Hi Brian, > > It's good to see someone new willing to contribute. > > Someone here will grant you access to SVN. You will need a way to > access SVN as well, which is depends on the OS you are using. I am > using Tortoise SVN for windows.http://tortoisesvn.tigris.org/ > > You will need to follow the Jallib style guide. This keeps code clean > and keeps things in order around > here.http://www.justanotherlanguage.org/content/jsg > > I created that 24lc256 lib, so I am interested to see the changes. > > Matt. > > On Oct 20, 4:42 pm, Brian Edmonson <[email protected]> wrote: > > > Hi all, > > > I'm pretty new to jallib. I've been trying out some example code for > > a while to see how I'd like using Jal as opposed to C or BASIC. I'm > > really enjoying it so far. > > > I was interested in using an eeprom chip I've had laying around for a > > while and noticed there was no library available for it. Long story > > short, I modified the 24lc256 library for use with the 24lc1025. I'd > > like to share it but I have no idea how to use the svn repository. > > > If anyone is interested, let me know what I need to do and i'll post > > the code. -- You received this message because you are subscribed to the Google Groups "jallib" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/jallib?hl=en.
