I didn't find anything shorter then the above, which seems the same as a regular read.
However, you could check the value of "reply" at the end sd_init procedure. I am getting 0x01. It should defiantly not be 0x00. .... print_byte_hex(serial_data, reply) end procedure I think it may be possible for the PC to read your card since there are two ways of doing data communication. spi and sd card bus (4 data lines). Maybe your cards spi or a spi pin is bad and the pc is using sd card bus. Matt. -- You received this message because you are subscribed to the Google Groups "jallib" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/jallib?hl=en.
