Hi hans,
this is what the program should do if the LED is connected to RC1 and GND (with
resistor):
The LED will slowly light up from off to 99% within one second,then it will
fade from 99% to 1% within another second.
The LED stays at 1% for half a second
PWM is disabled, so the LED will reflect the port pin, which is undefined by
default, for half a second
Then, PWM is reactivated and the LED will resume at 1% for 5 seconds, before
starting over again.
That is not what you're seeing?
Greets,Kiste
Am Sonntag, 3. April 2022, 16:10:38 MESZ hat hans
<[email protected]> Folgendes geschrieben:
A question from a friend. Attached is a test program for the use of the second
PWM port C1. The results are opposite to the assignment. On is off and off is
on. See the end of the file, the LED would go on for a long time but then it is
just off
--
You received this message because you are subscribed to the Google Groups
"jallib" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
To view this discussion on the web visit
https://groups.google.com/d/msgid/jallib/0fc3bf61-ee5b-435f-a883-fbe7e1f9188fn%40googlegroups.com.
--
You received this message because you are subscribed to the Google Groups
"jallib" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
To view this discussion on the web visit
https://groups.google.com/d/msgid/jallib/1281197392.784805.1649056861686%40mail.yahoo.com.
