Except that GO is a reserved word ;-) Dan Moderator at Large
On Tue, Dec 17, 2013 at 5:02 AM, mike ryder <[email protected]> wrote: > You can do it in code for VT100 type emulation - see > http://pwchest.no-ip.biz/qmweb/base/wiki?id=jslibs:vtcode for the escape > codes > > If you send HEX(1B2830) you will switch into a graphics mode and then send > HEX(1B2842) and you switch back to US ASCII output > > <codesnip> > GO = OCONV('1B2830','MX0C') > GX = OCONV('IB2842','MX0C') > TOPLEFT = OCONV('6C','MX0C') > PRINT GO:TOPLEFT:GX > </codesnip> > > The code snip will print the top left corner of a box. > > Mike > > > -- > -- > IMPORTANT: T24/Globus posts are no longer accepted on this forum. > > To post, send email to [email protected] > To unsubscribe, send email to [email protected] > For more options, visit this group at > http://groups.google.com/group/jBASE?hl=en > > --- > You received this message because you are subscribed to the Google Groups > "jBASE" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/groups/opt_out. > -- -- IMPORTANT: T24/Globus posts are no longer accepted on this forum. To post, send email to [email protected] To unsubscribe, send email to [email protected] For more options, visit this group at http://groups.google.com/group/jBASE?hl=en --- You received this message because you are subscribed to the Google Groups "jBASE" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
