It's been quite a while since there was any discussion of the LCD problem that a few of us have noticed on the later Controllers. (To recap: there is a small "patch" of distortion about half way up and 1cm from the right hand side which is noticable when some of the buttons are pressed - most especially the Play button).
I've been fiddling about a bit with my two controllers. It's possible to run a controller with the front plate removed, and in that configuration, the patch does not appear. This suggests that the problem is due to some mechanical interference between the unit and the front plate. So I next swapped the front plates over between the two controllers, but the patch remains on the newer controller, which implies the probem is with the actual workings of the controller rather than there being a difference between the front plates. I inspected the innards of the two controllers but I couldn't see any differences (apart from the change in what I assume is the WiFi antenna). Specifically, I wondered if perhaps the LCD screen itself might be slightly higher and therefore closer to the window in the front plate, but as far as I can tell with the naked eye, there is no difference here. I was wondering if anyone else has looked into this any more, and if so whether they've found anything new. -- cliveb Transporter -> ATC SCM100A ------------------------------------------------------------------------ cliveb's Profile: http://forums.slimdevices.com/member.php?userid=348 View this thread: http://forums.slimdevices.com/showthread.php?t=43982 _______________________________________________ jive mailing list [email protected] http://lists.slimdevices.com/cgi-bin/mailman/listinfo/jive
