Steiner is correct.
The "set interface <blah> enable" exists only for completeness, as
a complement to "set interface <blah> disable". If you have done
a disable, there are two ways to remove it:
set interface <blah> enable
or delete interface Mblah> disable
Both are functionally equivalent, however the former will clutter
the config file unnecessarily.
Paul Goyette
Juniper Networks Customer Service
JTAC Senior Escalation Engineer
PGP Key ID 0x53BA7731 Fingerprint:
FA29 0E3B 35AF E8AE 6651
0786 F758 55DE 53BA 7731
> -----Original Message-----
> From: [EMAIL PROTECTED]
> [mailto:[EMAIL PROTECTED] On Behalf Of
> [EMAIL PROTECTED]
> Sent: Thursday, April 12, 2007 6:11 AM
> To: [EMAIL PROTECTED]
> Cc: [EMAIL PROTECTED]
> Subject: Re: [j-nsp] set interface xxx enable
> Importance: High
>
> > Does anybody know what's different between the following
> configurations?
>
> As far as I know "enable" is the default, so these two configurations
> are functionally identical. From my point of view "enable" simply
> clutters the configuration here.
>
> Steinar Haug, Nethelp consulting, [EMAIL PROTECTED]
>
> >
> > (1).
> > [edit]
> > [EMAIL PROTECTED] show interfaces ge-0/2/0
> > unit 0 {
> > family inet {
> > address 10.31.31.1/24;
> > }
> > }
> >
> > (2).
> > [edit]
> > [EMAIL PROTECTED] show interfaces ge-0/2/0
> > enable;
> > unit 0 {
> > enable;
> > family inet {
> > address 10.31.31.1/24;
> > }
> > }
> >
> > Is there any advatages issueing command like "set interface
> ge-0/2/0
> > enable"?
> >
> >
> > Thanks,
> > Tan
> >
> _______________________________________________
> juniper-nsp mailing list [EMAIL PROTECTED]
> https://puck.nether.net/mailman/listinfo/juniper-nsp
>
_______________________________________________
juniper-nsp mailing list [EMAIL PROTECTED]
https://puck.nether.net/mailman/listinfo/juniper-nsp
