Hi Jeff, Since multilink ppp require adaptive service pic, Do I need any specific interface or junos ver for LACP in Juniper? I am planning to get P-1GE-SX interface so what type of gbic do it need in the Catalyst switch?
Regards, Samit Jeff Tantsura wrote: > Hi Samit, > > Not all of Cisco's support LACP, some PAGP only which is Cisco proprietary. > In this case you should configure Cisco in on mode and deactivate LACP on > Juniper. > > Regards, > Jeff > >> -----Original Message----- >> From: [EMAIL PROTECTED] [mailto:juniper-nsp- >> [EMAIL PROTECTED] On Behalf Of Samit >> Sent: woensdag 7 november 2007 12:36 >> To: [email protected] >> Subject: [j-nsp] STM-4 and Gig LACP Connectivity between Juniper and >> Ciscogear >> >> Hi, >> >> I am planning to get Juniper router and fit between two Cisco gear. >> Since I don't have any practical knowledge in juniper gear and junos, >> I would like to know expert opinion on any known issues working between >> Cisco and Juniper, STM and Gig interface and configs as per below figure. >> >> stm-4 -------------stm-4 Gig-----------Gig >> / \ / \ >> Cisco (Multilink PPP) Juniper (LACP) Catalyst >> \ / \ / >> stm-4 --------------stm-4 Gig-----------Gig >> >> Thanks in advance. >> >> Regards, >> Samit >> >> >> >> _______________________________________________ >> juniper-nsp mailing list [email protected] >> https://puck.nether.net/mailman/listinfo/juniper-nsp > > > _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
