Like someone else said, l2circuit is a Martini-style pw where you need
to specify the remote end of the pw as a targeted ldp session
"protocols l2circuit". There is no dynamic control protocol for the
setup/teardown of those sessions. l2vpn is the Kompella-style which
uses MP-BGP as the control protocol for the setup of those sessions.
There is no direct replacement for L2TPv3 pw on the Juniper platform,
since it doesn't support L2TPv3; it must run over MPLS. You can do
MPLS over a GRE tunnel if you want to go over an IP network in the
middle.
Phil
On Jan 8, 2009, at 12:50 PM, Andrew Jimmy wrote:
What are the major differences between l2cirucit and l2vpn in terms of
Juniper JUNOS. Which is best in replacing Cisco L2TPv3 pseudo-wr.
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
