From the 9.3 release notes:
"On M20 routers running JUNOS Release 9.3 and later, nonenhanced FPCs do
not come online because of memory limitations. These FPCs appear as
FPC in
the Description column of the output from the show chassis hardware
command.
As announced in Technical Bulletin PSN-2004-08-024, these FPCs have
not been
supported since 31 December 2004. (To access the bulletin, log in at
https://www.juniper.net/alerts/viewalert.jsp?txtAlertNumber=PSN-2004-08-024&actionBtn=Search.)
[PR/291610]"
--Stacy
On May 6, 2009, at 8:14 AM, Eric Van Tol wrote:
Hi all,
Is anyone out there running 9.3 with an M20 FPC (not FPC-E). I have
a lab box that I've upgraded to 9.3R2.8 and the FPC won't come up.
The only PIC in this FPC is a P-4CHDS3 PIC. The FPC basically goes
from "Present" state to "Offline" within a few minutes of booting:
May 5 15:07:06 m20 ssb CM(0): Slot 0: No response from FPC
interface manager
May 5 15:07:06 m20 chassisd[4671]: CHASSISD_FRU_EVENT:
scb_recv_slot_detach: detached FPC 0
May 5 15:07:06 m20 ssb CM(0): Slot 0: No response from FPC chassis
manager
May 5 15:07:06 m20 chassisd[4671]: CHASSISD_IFDEV_DETACH_FPC:
ifdev_detach(0)
May 5 15:07:06 m20 ssb CM(0): Slot 0: Unrecoverable error; probe
failed
I would normally open a ticket, but this is a lab box not under
contract that I'm using to test some stuff out on. Everything works
fine with 9.0R2.10. Juniper support site says FPC and this PIC are
a valid combination for 9.3, so I'm at a loss here.
-evt
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
