On Sun, Jul 11, 2010 at 01:05:41AM +0200, John Wilkes wrote: > On Sun, Jul 11, 2010 at 12:28 AM, Phil Mayers <[email protected]> wrote: > > Your direct test I would expect to fail; pulling the TX fibre will cause the > > far end to signal fault and bring the entire link down. > > Yes, the far end. But I meant I connected both TX and RX between two ports. > That made them both come up (of course). But when I pulled just one TX > they both went down.
Try disabling Autonegotiation on the EX4200-24F ports and see if the one-way link comes up then: set interfaces ge-0/1/0 ether-options no-auto-negotiation set interfaces ge-0/1/0 ether-options speed 1g set interfaces ge-0/1/0 ether-options link-mode full-duplex _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
