Hello, I would like to distribute routes from my CPE (Cisco 877) to my ERX. CPE's are connectec via PPP. On the CPE i configured: router rip version 2 network 10.0.0.0 no auto-summary Config says network 10.0.0.0 but because I used no auto-summary it sends 10.64.63.0
On my ERX I configured: router rip version 2 address 10.32.3.254 The address is the adress from the loopback interface used for the ppp 10.32.3.254, Rip is up, loopback209 Send version = 2 Receive version = 2 Authentication mode = none Default metric = 1 Passive Interface = No Access-list applied to outgoing route = none Access-list applied to incoming route = none Route-map applied to outgoing route = none Received bad packet = 0 Received bad routes = 0 Triggered updates sent = 0 Received updates = 0 -------------------------------------------------------------------- I'm not receiving the routes, also tried with neighborh statement. Kind regards, Tom _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
