Found a solution: On my loopback interface i used for the pppoe i had to enter the following command: ip rip copy-to-dynamic
Kind regards, Tom ________________________________________ Van: Tom Teeuwen Verzonden: zaterdag 6 november 2010 17:03 Aan: [email protected] Onderwerp: RE: ERX route distribution via RIP My logging shows the following: DEBUG 11/06/2010 11:01:38 ripRoute (myvirtualrouter): can't receive, circuit not found Someone an idee what it is ? ________________________________________ Van: [email protected] [[email protected]] namens Tom Teeuwen [[email protected]] Verzonden: vrijdag 5 november 2010 9:18 Aan: [email protected] Onderwerp: [j-nsp] ERX route distribution via RIP Hello, I would like to distribute routes from my CPE (Cisco 877) to my ERX. CPE's are connectec via PPP. On the CPE i configured: router rip version 2 network 10.0.0.0 no auto-summary Config says network 10.0.0.0 but because I used no auto-summary it sends 10.64.63.0 On my ERX I configured: router rip version 2 address 10.32.3.254 The address is the adress from the loopback interface used for the ppp 10.32.3.254, Rip is up, loopback209 Send version = 2 Receive version = 2 Authentication mode = none Default metric = 1 Passive Interface = No Access-list applied to outgoing route = none Access-list applied to incoming route = none Route-map applied to outgoing route = none Received bad packet = 0 Received bad routes = 0 Triggered updates sent = 0 Received updates = 0 -------------------------------------------------------------------- I'm not receiving the routes, also tried with neighborh statement. Kind regards, Tom _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
