Rafael, Thank you for this but i managed to set this up almost 3 hours after i posted this thread, and i have BGP running fine now.
cheers On Tue, Feb 15, 2011 at 10:42 PM, Rafael Rodriguez <[email protected]>wrote: > Hi David, > > You probably want to look into: > > http://www.juniper.net/techpubs/software/screenos/screenos6.3.0/630_ce_all.pdf > > Should be in Routing -> Border Gateway Protocol. > > BTW, this covers BGP on screenos based devices and not junos devices. > > On Tue, Feb 1, 2011 at 3:22 AM, David Lubowa <[email protected]>wrote: > >> Hi Guys, >> >> I am pretty virgin when it comes to Juniper but i switched because i think >> its amazing gear , i am trying to configure BGP on my SSG550M using a >> private ASN( just for now ) to my upstream but i am not sure where to >> start >> i have looked for some documentation online but i am still not yet >> convinced >> on which is the right documentation because the information is all >> scattered. >> >> If someone could please point me in the right direction i would be happy , >> FYI i setup BGP on cisco gear a couple of years ago and i understand the >> basic facts of BGP but i am not sure exactly how to set it up on Juniper. >> >> Your help is highly appreciated. >> >> cheers >> >> >> -- >> >> >> >> >> >> "I will not say i failed 1000 Times, I will say that i discovered there >> are >> 1000 ways that can cause failure. ---- Thomas Edison" >> _______________________________________________ >> juniper-nsp mailing list [email protected] >> https://puck.nether.net/mailman/listinfo/juniper-nsp >> > > -- "I will not say i failed 1000 Times, I will say that i discovered there are 1000 ways that can cause failure. ---- Thomas Edison" _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
