It will help me to narrowdown this issue. Thanks
On Sat, Jun 25, 2011 at 9:23 PM, Alex <[email protected]> wrote: > If the BGP peer in the master Routing Engine has negotiated address-family > capabilities that are not supported for nonstop active routing, then the > corresponding BGP neighbor state on the backup Routing Engine shows as idle. > On switchover, the BGP session is reestablished from the new master Routing > Engine. > http://www.juniper.net/**techpubs/en_US/junos11.1/** > topics/reference/requirements/**nsr-system-requirements.html#**nsr-bgp<http://www.juniper.net/techpubs/en_US/junos11.1/topics/reference/requirements/nsr-system-requirements.html#nsr-bgp> > Note, for instance, inet-vpn multicast AFI is not supported for NSR. > HTH > Rgds > Alex > > > ----- Original Message ----- From: "saurabh sood" <[email protected]> > To: <[email protected]> > Sent: Saturday, June 25, 2011 2:40 PM > Subject: [j-nsp] Output for "show bgp summary" is showing different on > twoREs > > > Hello, >> >> I have observed a different scenario, i don't know wthr it is by expected >> or >> not. >> >> Router has two REs and GRES, NSR is enabled also commit synchronize is >> there. >> But while checking the output for "show bgp summary" then on Master RE >> everything is showing ok. >> >> On the other hand backup RE is showing all bgp states IDLE. >> >> Is it an expected behavior? >> >> Regards, >> >> Sunny >> ______________________________**_________________ >> juniper-nsp mailing list [email protected] >> https://puck.nether.net/**mailman/listinfo/juniper-nsp<https://puck.nether.net/mailman/listinfo/juniper-nsp> >> >> > _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
