HI, You can see what you are advertising to specific neighbor with:
show route advertising-protocol bgp <neigbor ip address> HTH, Ivan, On Thu, Jan 5, 2012 at 12:41, Affandi Indraji <[email protected]>wrote: > Hi, > > I understand that doing the origination from Junos is slightly different > from Cisco. > > Cisco: > - configure the network statement in the "router bgp" > - configure the null route (or as long as the routes is in the routing > table) it will be available in the BGP routing table > - when we do the "sh ip bgp x.x.x.x" in the cisco router where we originate > x.x.x.x, it will be shown in the BGP routing table > > Junos: > - configure discard static routes in "routing option" > - configure the policy statement to match the prefix that we configure in > the discard static route > - configure the policy statement into the "export" policy to the bgp > session that we want that origin routes to be announced > - if we do "show route protocol bgp x.x.x.x" in the router where we > originate the routes, we won't be able to see it int the BGP table. > > Question: > 1. Is there a way to put the routes that we originate in to the BGP routing > table in the same router? what i mean is, if i originate > 100.100.100.0/24from router A, i also want to see > 100.100.100.0/24 inside the BGP table in router A too (like cisco). Is > this > possible? > 2. Is there any best practice to originate routes in Junos since it behave > differently compare to cisco? > > Thank you. > > Regards, > Affandi > _______________________________________________ > juniper-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/juniper-nsp > -- Best Regards! Ivan Ivanov _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
