Hello,
Weight is a Cisco proprietary thing and cannot be used with a Juniper
device. Maybe you could use preference (not local-preference).
On 11/25/2012 10:03 AM, Ali Sumsam wrote:
Hi All,
I am configuring BGP for one of my customer's MX-5 router. I need to
configure the BGP attribute "weight"
Is there any way of assigning "weight" attribute on subnets learned from an
EBGP peer.
Cisco config of this is as following.
router bgp 123
neighbor pipe-bne soft-reconfiguration inbound
neighbor pipe-bne route-map ABC-IN in
route-map ABC-IN permit 10
set weight 1500
I googled it and found following, which kinda says that we cant play with
weight attribute in policies. Is this correct?
http://www.juniper.net/techpubs/software/erx/erx41x/swconfig-routing-vol2/html/bgp-config9.html
Regards,
*Ali Sumsam CCIE*
*Network Engineer - Level 3*
eintellego Pty Ltd
[email protected] ; www.eintellego.net
Phone: 1300 753 383 ; Fax: (+612) 8572 9954
Cell +61 (0)410 603 531
facebook.com/eintellego
PO Box 7726, Baulkham Hills, NSW 1755 Australia
The Experts Who The Experts Call
Juniper - Cisco – Brocade - IBM
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
