Hey all, I haven't found an answer to this question (except for Cisco options which doesn't help me). I want to configure a static route to a DHCP interface on an SRX240. Here's the scenario:
ge-0/0/0 connected to CX111 (4G modem/DHCP) t1-0/1/0 connected to an L3VPN (with BGP) st0.0 should connect over ge-0/0/0 The t1 is considered trusted, so we do not want to form the IPSec tunnel over it. There is a default route coming in via BGP on the T1. The goal: Statically route the IPSec tunnel endpoint over the 4G modem as a /32 Statically route 0/0 over st0.0 (and set precedence to >170, or set BGP down to 4) Receive 0/0 from BGP over the T1 (or alternately not, with no need to alter precedence, and use two next-hops for one static 0/0) The purpose is to have the tunnel up but not used until the T1 or BGP over it goes away. However, I cannot set ge-0/0/0.0 as the next-hop because it's not a point to point interface. I cannot set an IP address as the next-hop because I don't know when it will change. Any ideas on how to address that? Thanks! Aaron _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
