Ah~ M20 does not support 10GE interface, also M20 is already EOL. MX could be good choice, see
http://www.juniper.net/us/en/local/pdf/datasheets/1000378-en.pdf for MX80 cards, and http://www.juniper.net/us/en/products-services/routing/mx-series/ for all MX series. -- Michel~ On Tue, Apr 9, 2013 at 7:07 PM, Jonathan Lassoff <[email protected]> wrote: > I think you'll need at least an M20 for your 10 GigE requirement as well as > SDH. > > If you can somehow get a different transit circuit than your SDH one, an > MX5 would be a much closer (throughput-wise) and better bang-for-your-buck > replacement for a 7206 than an M-series. > J-series with a T1 module could also work, depending on your "STM-1". > > If you need SDH though, you'll need M or T. J can do T1s. > > --j > > On Tue, Apr 9, 2013 at 6:28 PM, Orlando Cordova Gonzales < > [email protected]> wrote: > >> hello, >> >> I need to change a CISCO 7206 router that computer I recommend one of the >> requirements is that you have two 10G interfacez two interfacez 1G and STM1 >> interface to connect with the ISP was thinking M10i Router but I do not >> support 10g interface. >> >> thank you very much for your help. >> _______________________________________________ >> juniper-nsp mailing list [email protected] >> https://puck.nether.net/mailman/listinfo/juniper-nsp >> > _______________________________________________ > juniper-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/juniper-nsp _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
