We haven't had any issues using Prolabs 3rd party SFP's in MX platform before at 100meg at least on DPCE cards - can't remember if we ever tried with Juniper "authentic" before or notĀ Also we have used them on MX80 platform (20x1 GE MIC card)
Paul On 2013-05-01 2:20 PM, "Serge Vautour" <[email protected]> wrote: >Very likely no. What's the SFP model number and the line card type you're >using on the MX? > >Serge > > > >________________________________ > From: Keith <[email protected]> >To: [email protected] >Sent: Tuesday, May 10, 2011 8:59:06 PM >Subject: [j-nsp] 1000BaseT SFP > > > >Trying to connect GE copper SFP on MX to a 100meg port on a cisco switch, >3560 actually. > > >ge-0/0/2 { description "<< Test Link >>"; enable; speed 100m; link-mode >full-duplex; unit 0 { family inet { address 192.168.1.2/26; show >interface ge-0/0/2: Physical interface: ge-0/0/2, Enabled, Physical link >is Up Interface index: 136, SNMP ifIndex: 511 Description: << Test Link >>> Link-level type: Ethernet, MTU: 1514, Speed: 100mbps, BPDU Error: >>>None, MAC-REWRITE Error: None, Loopback: Disabled, Source filtering: >>>Disabled, Flow control: Enabled, Auto-negotiation: Enabled, Remote >>>fault: Online Device flags : Present Running Interface flags: >>>SNMP-Traps Internal: 0x4000 Link flags : None CoS queues : 8 >>>supported, 8 maximum usable queues Current address: 80:71:1f:91:10:02, >>>Hardware address: 80:71:1f:91:10:02 Last flapped : 2011-04-28 >>>13:44:09 PDT (1w5d 03:08 ago) Input rate : 0 bps (0 pps) Output >>>rate : 0 bps (0 pps) Active alarms : None Active defects : None >>>Logical interface ge-0/0/2.0 (Index 74) (SNMP ifIndex 522) Flags: >>>SNMP-Traps > 0x4000000 Encapsulation: ENET2 Input packets : 0 Output packets: 19 >Protocol inet, MTU: 1500 Flags: Sendbcast-pkt-to-re Addresses, Flags: >Is-Preferred Is-Primary Destination: 192.168.1.0/26, Local: 192.168.1.2, >Broadcast: 192.168.1.63 Protocol multiservice, MTU: Unlimited Swapped >cables etc, my question is can these 1000BaseT SFP's work at 100M? I can >configure them as such >but do they actually work at 100M? Thanks, >Keith > > > >_______________________________________________ >juniper-nsp mailing list [email protected] >https://puck.nether.net/mailman/listinfo/juniper-nsp >_______________________________________________ >juniper-nsp mailing list [email protected] >https://puck.nether.net/mailman/listinfo/juniper-nsp _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
