I think you need to specifically use the tri-state SFPs for this to work SFP-1GE-FE-E-T SFP capable of support 10/100/1000 speeds
On May 10, 2011, at 6:59 PM, Keith <[email protected]> wrote: Trying to connect GE copper SFP on MX to a 100meg port on a cisco switch, 3560 actually. ge-0/0/2 { description "<< Test Link >>"; enable; speed 100m; link-mode full-duplex; unit 0 { family inet { address 192.168.1.2/26; show interface ge-0/0/2: Physical interface: ge-0/0/2, Enabled, Physical link is Up Interface index: 136, SNMP ifIndex: 511 Description: << Test Link >> Link-level type: Ethernet, MTU: 1514, Speed: 100mbps, BPDU Error: None, MAC-REWRITE Error: None, Loopback: Disabled, Source filtering: Disabled, Flow control: Enabled, Auto-negotiation: Enabled, Remote fault: Online Device flags : Present Running Interface flags: SNMP-Traps Internal: 0x4000 Link flags : None CoS queues : 8 supported, 8 maximum usable queues Current address: 80:71:1f:91:10:02, Hardware address: 80:71:1f:91:10:02 Last flapped : 2011-04-28 13:44:09 PDT (1w5d 03:08 ago) Input rate : 0 bps (0 pps) Output rate : 0 bps (0 pps) Active alarms : None Active defects : None Logical interface ge-0/0/2.0 (Index 74) (SNMP ifIndex 522) Flags: SNMP-Traps 0x4000000 Encapsulation: ENET2 Input packets : 0 Output packets: 19 Protocol inet, MTU: 1500 Flags: Sendbcast-pkt-to-re Addresses, Flags: Is-Preferred Is-Primary Destination: 192.168.1.0/26, Local: 192.168.1.2, Broadcast: 192.168.1.63 Protocol multiservice, MTU: Unlimited Swapped cables etc, my question is can these 1000BaseT SFP's work at 100M? I can configure them as such but do they actually work at 100M? Thanks, Keith _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
