On 24/07/13 16:07, Phil Mayers wrote:
On 24/07/13 15:48, Stacy W. Smith wrote:
In general, I see no problems with your AE configuration.
Could you define "never comes up"? Is it the ae0 interface, or the
ae0.999 unit that is in a down state?
Both (see below)
Interestingly, this comes up if you use "sub-ints" on the Cisco side:
interface port-channel20
interface port-channel20.999
encapsulation dot1q 999
ip address 192.168.1.1/31
no shutdown
...as opposed to
interface port-channel20
switchport
switchport mode trunk
switchport trunk allowed vlan 999
int Vlan999
ip address 192.168.1.1/31
no shutdown
Clearly there's some sort of LACP-layer parameter that corresponds to
"trunk" versus "not" - can this be influenced by the specific "style" of
ae0 config on the SRX side?
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
