That's a fault.
Grab an OTDR and test from each end to determine where it is (and test
the optics, of course)
Could be dirty optics, dirty / damaged connector, damaged fibre....
On Fri, 24 Jan 2014 00:14:19 +1100, Ali Sumsam wrote:
Hi All,
I am using a SFP-10GBase-ER for my Cisco3750X for a 10gig link going
to a
Juniper MX5-T router (10GE XFP)
I am receiving following logs on my Cisco3750X.
%SFF8472-5-THRESHOLD_VIOLATION: Te1/1/2: Rx power low alarm;
Operating
value: -21.3 dBm, Threshold value: -20.0 dBm.
No logs on Juniper.
Does this mean I have to increase the power on the interface?
Or is there anything else I need to look at?
Following are the readings from my Juniper router.
Laser rx power high alarm threshold : 1.2589 mW / 1.00 dBm
Laser rx power low alarm threshold : 0.0158 mW / -18.01
dBm
Laser rx power high warning threshold : 1.0000 mW / 0.00 dBm
Laser rx power low warning threshold : 0.0199 mW / -17.01
dBm
Regards,
*Ali Sumsam - *eintellego Networks Pty Ltd
Senior Network Engineer
[email protected] ; www.eintellegonetworks.com
Phone: 1300 239 038; Cell +61 (0)450 609 592 ; skype://sumsam.ali80
facebook.com/eintellegonetworks ; <http://twitter.com/networkceoau>
linkedin.com/in/alisumsam
The Experts Who The Experts Call
Juniper - Cisco - Cloud
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
