Are you in flow mode or packet mode? If flow mode, don't forget to modify the appropriate security policies as these will block messages.
On Wed, Aug 27, 2014 at 5:07 PM, Keith <[email protected]> wrote: > Hi. > > We have been taking our first foray into multicast the last few days. > > In our test bed we have an SRX240 with all the senders and one receiver > connected. > > Sender is pushing 600megs of traffic on ge-0/0/3 > > Receiver is on ge-0/0/8, both interfaces on vlan 100. > > Receiver used to be on vlan 51, but it was not receiving *any* multicast > traffic > at all. So as a test we moved ge-0/0/8 to the same vlan as the sender to > see if > the test set could see the groups and it can. > > But ge-0/0/8 is drowning in traffic from the sender. I have igmp-snooping, > interfaces > on igmp, pim enabled, but I see 640 megs of traffic input on ge-0/0/3 and > 640 megs > output on ge-0/0/8. > > I have multicast routes showing up in the routing table. > > Couple of show commands says that igmp is not enabled on ge-0/0/8. > > run show igmp statistics interface ge-0/0/8 >>> >> > IGMP not enabled on interface ge-0/0/8.0 > > IGMP Global Statistics > Bad Length 0 > Bad Checksum 0 > Bad Receive If 0 > Rx non-local 0 > Timed out 3 > Rejected Report 0 > Total Interfaces 4 > > I have obviously missed something in the protocols section but I have > no idea what. Anyone lend a clue? > > show protocols >>> >> igmp { > accounting; > interface ge-0/0/8.0; > interface ge-0/0/3.0; > interface vlan.100; > interface vlan.51; > interface vlan.49; > } > inactive: ospf { > area 0.0.0.0 { > interface all; > } > } > pim { > inactive: traceoptions { > file pim-trace.log; > flag all; > flag join detail; > flag prune detail; > } > interface all { > mode sparse; > version 2; > } > interface vlan.51 { > mode sparse; > version 2; > } > interface vlan.49 { > mode sparse; > version 2; > } > interface vlan.100 { > mode sparse; > version 2; > } > interface ge-0/0/8.0 { > mode sparse; > version 2; > } > } > igmp-snooping { > vlan vlan.51; > vlan vlan.49; > vlan vlan.100; > } > > Thanks, > Keith > _______________________________________________ > juniper-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/juniper-nsp > -- *Tyler Christiansen | Technical Operations* tyler <http://adap.tv/>@adap.tv <http://adap.tv/> | www.adap.tv *m :* 864.346.4095 _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
