> Are you in flow mode or packet mode? If flow mode, don't forget to modify > the appropriate security policies as these will block messages. >
Its in flow mode and have security policy of allow everything as this is an isolated network with no outside access of any kind. I have thought about putting it into packet mode just to try it out anyway. Thanks, Keith > > On Wed, Aug 27, 2014 at 5:07 PM, Keith <[email protected]> wrote: > >> Hi. >> >> We have been taking our first foray into multicast the last few days. >> >> In our test bed we have an SRX240 with all the senders and one receiver >> connected. >> >> Sender is pushing 600megs of traffic on ge-0/0/3 >> >> Receiver is on ge-0/0/8, both interfaces on vlan 100. >> >> Receiver used to be on vlan 51, but it was not receiving *any* multicast >> traffic >> at all. So as a test we moved ge-0/0/8 to the same vlan as the sender to >> see if >> the test set could see the groups and it can. >> >> But ge-0/0/8 is drowning in traffic from the sender. I have >> igmp-snooping, >> interfaces >> on igmp, pim enabled, but I see 640 megs of traffic input on ge-0/0/3 >> and >> 640 megs >> output on ge-0/0/8. >> >> I have multicast routes showing up in the routing table. >> >> Couple of show commands says that igmp is not enabled on ge-0/0/8. >> >> run show igmp statistics interface ge-0/0/8 >>>> >>> >> IGMP not enabled on interface ge-0/0/8.0 >> >> IGMP Global Statistics >> Bad Length 0 >> Bad Checksum 0 >> Bad Receive If 0 >> Rx non-local 0 >> Timed out 3 >> Rejected Report 0 >> Total Interfaces 4 >> >> I have obviously missed something in the protocols section but I have >> no idea what. Anyone lend a clue? >> >> show protocols >>>> >>> igmp { >> accounting; >> interface ge-0/0/8.0; >> interface ge-0/0/3.0; >> interface vlan.100; >> interface vlan.51; >> interface vlan.49; >> } >> inactive: ospf { >> area 0.0.0.0 { >> interface all; >> } >> } >> pim { >> inactive: traceoptions { >> file pim-trace.log; >> flag all; >> flag join detail; >> flag prune detail; >> } >> interface all { >> mode sparse; >> version 2; >> } >> interface vlan.51 { >> mode sparse; >> version 2; >> } >> interface vlan.49 { >> mode sparse; >> version 2; >> } >> interface vlan.100 { >> mode sparse; >> version 2; >> } >> interface ge-0/0/8.0 { >> mode sparse; >> version 2; >> } >> } >> igmp-snooping { >> vlan vlan.51; >> vlan vlan.49; >> vlan vlan.100; >> } >> >> Thanks, >> Keith >> _______________________________________________ >> juniper-nsp mailing list [email protected] >> https://puck.nether.net/mailman/listinfo/juniper-nsp >> > > > > -- > > *Tyler Christiansen | Technical Operations* > tyler <http://adap.tv/>@adap.tv <http://adap.tv/> | www.adap.tv > *m :* 864.346.4095 > _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
