-idle before, takes 10-15 minutes to settle after full table is ingested -1m -no 64-bit release for mx80
On Tue, Jan 6, 2015 at 5:13 PM, Masood Ahmad Shah <[email protected]> wrote: > Jordan, > > How does CPU utilization looks during these 3 minutes (even a minute > before and after)? > How many routes (prefixes) you have in the RIB (not just active, the total > number of prefixes that are being scanned to find out the best routes > "adj-in-rib")? > With 14.1R3.5, did you use rpd-64bit or 32bit? > > Cheers, > Masood > > > On Sun, Jan 4, 2015 at 9:30 AM, Jordan Whited <[email protected]> > wrote: > >> I don't have any issues when sampling is disabled. >> >> No improvement from what I can tell between 12.3R8.7 and 14.1R3.5. Still >> seeing active-paths in the RIB advertised to other neighbors for upwards >> of >> 3 minutes before they are installed in the FIB. >> >> On Sat, Dec 13, 2014 at 3:34 AM, MSusiva <[email protected]> wrote: >> >> > I assume, the 3mins result is with sampling? >> > What is the result without sampling? >> > Did you test in 14.1 with sampling? >> > >> > Thank You >> > _______________________________________________ >> > juniper-nsp mailing list [email protected] >> > https://puck.nether.net/mailman/listinfo/juniper-nsp >> > >> _______________________________________________ >> juniper-nsp mailing list [email protected] >> https://puck.nether.net/mailman/listinfo/juniper-nsp >> > > _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
