> Hi chris
> Could you pls send me a concrete config example of your last statement:
>
> " - You can put a VPLS into an L3VPN by defining a routing-interface irb.xx
> into the VPLS (VPLS then requies vlan tagging i.e. vlan-id defined in the
> VPLS)
> ....then including the same irb.xxx interface in the L3VPN interfaces list.
> You can put multiple VPLSs in this way (1 irb.xx per VPLS, and multiple
> irb.xx in the L3VPN)"
>
> Thanks
>
something like:
interfaces {
irb {
unit 100 {
family inet {
address 1.1.1.0/24;
}
}
unit 200 {
family inet {
address 2.2.2.0/24;
}
}
}
}
}
routing-instances {
VPLS1 {
instance-type vpls;
vlan-id 100;
routing-interface irb.100;
interface ge-0/0/0.100;
vrf-target target:65535:1;
protocols {
vpls {
no-tunnel-services;
site X {
site-identifier 1;
}
}
}
VPLS2 {
instance-type vpls;
vlan-id 200;
routing-interface irb.200;
interface ge-0/0/0.200;
vrf-target target:65535:2;
protocols {
vpls {
no-tunnel-services;
site Y {
site-identifier 1;
}
}
}
L3VPN {
instance-type vrf;
interface irb.100; // VPLS 1
interface irb.200; // VPLS 2
vrf-target target:65535:3;
vrf-table-label;
}
}
cc'ed to list to share the knowledge.
- CK.
On 12/03/2015, at 11:29 PM, james list <[email protected]> wrote:
>
> Il 11/mar/2015 23:09 "Chris Kawchuk" <[email protected]> ha scritto:
> Yes.
>
> - L2CKTs can be mapped into a VPLS using an LDP Mesh Group [routing-instances
> XXXX protocols vpls mesh-group vpls-id neighbour xxxx]
> - L2VPNs can be mapped into a VPLS using stitched lt-* interfaces (interfaces
> lt-1/0/10.1 <> lt-1/0/10.2 peer unit 1 etc.. encapsulation vlan-vpls /
> vlan-ccc)
> - You can put a VPLS into an L3VPN by defining a routing-interface irb.xx
> into the VPLS (VPLS then requies vlan tagging i.e. vlan-id defined in the
> VPLS)
> ....then including the same irb.xxx interface in the L3VPN interfaces list.
> You can put multiple VPLSs in this way (1 irb.xx per VPLS, and multiple
> irb.xx in the L3VPN)
>
> - CK.
>
>
> On 12/03/2015, at 1:43 AM, james list <[email protected]> wrote:
>
> > Hi folks
> > It there a way, in a vpls configuration with MX, to map multiple L2 and
> > multiple L3 in the same vpls instance ?
>
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
