http://forums.juniper.net/t5/Ethernet-Switching/Disable-Virtual-Chasis-on-EX4200/td-p/46663
Specifically: First delete all config under "edit virtual-chassis", but to remove all evidence of vc on it you need to go into the shell: Start shell Delete all files under /config/vchassis rm *.* Remove or disable the vcp cable and reboot to purge. Cli request system reboot. Worked for me in the past. Applies to EX 4200, not sure if EX 4300 is same. Hope this helps. richg On Thu, Aug 13, 2015 at 7:29 PM, Giuliano (WZTECH) <[email protected]> wrote: > Have you tried to remove the vc-ports ? > > Sent from my iPhone > > > On Aug 13, 2015, at 23:19, Scott Granados <[email protected]> > wrote: > > > > I tried this one and it errors out because the node was active. > > > > Thanks > > Scott > > > >> On Aug 13, 2015, at 9:34 PM, Giuliano (WZTECH) <[email protected]> > wrote: > >> > >> Request virtual-chassis recycle and renumber you can put the switch as > a master stand alone > >> > >> Sent from my iPhone > >> > >>> On Aug 13, 2015, at 22:23, Scott Granados <[email protected]> > wrote: > >>> > >>> Hi, > >>> Have some EX 4300s that I want to break apart and start like they were > factory new and reboot. I know about the factory default button on the > front and the configuration option but no matter how I apply that I still > have the node boot thinking it’s a member of the previous chassis. How do > I delete it’s membership when it’s active / a stand alone node? > >>> > >>> Any pointers are most appreciated. > >>> > >>> Thank you > >>> Scott > >>> > >>> _______________________________________________ > >>> juniper-nsp mailing list [email protected] > >>> https://puck.nether.net/mailman/listinfo/juniper-nsp > > > _______________________________________________ > juniper-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/juniper-nsp _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
