double check the console port config... . It's under system ports console
On Thu, Dec 31, 2015 at 9:11 AM, Eric Van Tol <[email protected]> wrote: > Hi all, > I have been struggling for the past day to get my EX4200 console ports to > work on an MRV LX4000T console server and something is just not right. I'm > hoping someone else may have come across this or tell me where I'm being > stupid. > > I'm using a rolled cable that works fine with the SRX and various Cisco > consoles. Console server is configured with 8N1, no flow control, 9600bps, > but when I try to connect to the EX, I get gibberish on the screen and > framing errors showing up in the port stats on the console server. Pinouts > for both the EX and SRX (and I imagine all Juniper gear) are the same: > > EX: > > http://www.juniper.net/techpubs/en_US/release-independent/junos/topics/reference/specifications/port-ex-series-console-connector-pinout.html > > SRX: > > http://www.juniper.net/techpubs/en_US/release-independent/junos/topics/reference/specifications/rj45-connector-pinout-srx110-for-console-port.html > > I cannot figure out what's going on with the EX. Again, cable has been > tested with multiple other kit, so it's not a cable issue AFAIK. > > Thanks, > evt > > _______________________________________________ > juniper-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/juniper-nsp > _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
