Yeah, strange my subinterface doesn't show any packets out, but the phy int
shows currently 17 mbps going out right now...
Maybe these counters are broken on the subint... I tried walking with snmp but
I still didn't see any traffic for the subinterface used on the l2circuit
agould@blcn-h-5048> show interfaces ge-0/0/12 statistics
Physical interface: ge-0/0/12, Enabled, Physical link is Up
Interface index: 650, SNMP ifIndex: 521
Link-level type: Ethernet-CCC, MTU: 1514, LAN-PHY mode, Speed: 1000mbps, BPDU
Error: None, MAC-REWRITE Error: None, Loopback: Disabled,
Source filtering: Disabled, Flow control: Disabled, Auto-negotiation:
Enabled, Remote fault: Online, Media type: Copper
Device flags : Present Running
Interface flags: SNMP-Traps Internal: 0x4000
Link flags : None
CoS queues : 8 supported, 8 maximum usable queues
Current address: 20:4e:71:45:12:34, Hardware address: 20:4e:71:45:12:34
Last flapped : 2016-05-25 14:38:24 CDT (3w5d 01:55 ago)
Statistics last cleared: Never
Input rate : 17802616 bps (1633 pps)
Output rate : 0 bps (0 pps)
Input errors: 0, Output errors: 0
Active alarms : None
Active defects : None
Interface transmit statistics: Disabled
Logical interface ge-0/0/12.0 (Index 557) (SNMP ifIndex 523)
Flags: Up SNMP-Traps 0x4004000 Encapsulation: Ethernet-CCC
Input packets : 68
Output packets: 0
Protocol ccc, MTU: 1514
Flags: Is-Primary
{master:0}
agould@blcn-h-5048> show l2circuit connections brief
Layer-2 Circuit Connections:
Legend for connection status (St)
....
Legend for interface status
Up -- operational
Dn -- down
Neighbor: 10.101.0.1
Interface Type St Time last up # Up trans
ge-0/0/12.0(vc 1) rmt Up May 25 14:38:24 2016 1
- Aaron
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
