Hi Eduardo, On 29 November 2016 at 08:35, Eduardo Schoedler <[email protected]> wrote: > > Here on EX2200 I put ip address directly in the vlan. > > Try this: > > set interfaces vlan unit xxx family inet address 10.x.x.x/24 > set vlans vlan-RESEAUX l3-interface vlan.xxx > set interfaces ge-0/x/x unit 0 family ethernet-switching vlan members > vlan-RESEAUX
EX4600 runs Enhanced Layer 2 Software (ELS), so it's correct to use "irb.n" vs. "vlan.n" I assume Deloin's config was hand-typed because it should be "l3-interface" rather than "l3.interface". As someone else pointed out, if the link is point-to-point, only .4 and .5 will be reachable. xe-0/0/1 is the 2nd (bottom left) interface. We need some more "show" outputs and/or a complete config to figure out what's going on. Cheers, Dale _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
