Insert a 3dB or 7dB attenuator pad for lab testing. In a pinch (no pun intended) you can take a fiber jumper and bend it tightly into a loop (like 1/4" diameter) to attenuate the signal, but I would use a disposable jumper for that. Use a twist tie or similar to hold it in the tight loop. Monitor the receive power level while adjusting the tightness of the loop until it is lower than -5 dBm but higher than -20 dBm.
On Wed, Oct 04, 2017 at 07:04:05PM -0500, Aaron Gould wrote: > Well, when the transport eng I work with found out that I had these two 40km > optics connected with a 3’ jumper he ran into the lab to disconnect it…. So > that’s probably why you see no light right now…. Lemme get back into the > office Monday and we will go from there… yeah, as I mentioned I’m working > with my Juniper account SE on this, so he may update support matrix if he > discovers they are good…. I dunno. _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
