Hi Jeff, What type of DPC card you're using? As per your initial email I wouldn't expect PIC 4 on DPC card related to gr-5/4/0 interface to be present as PICs can take numbers between 0 and 3. What is your network-services mode (show chassis network-services)? Is DPC card up (show chassis fpc)?
As per documentation, if you specify a bandwidth that is not compatible, tunnel services are not activated. For example, you cannot specify a bandwidth of 1 Gbps for a Packet Forwarding Engine on a 10-Gigabit Ethernet 4-port DPC. Have you verified with "show interfaces gr-* terse" if any GRE interface is created? If you're using DPC 40x1GE then tunnel interfaces shall be gr-x/[0-3]/10 (set chassis fpc X pic Y bandwidth 1g) and with DPC 4x10GE it shall be gr-x/[0-3]/0 (set chassis fpc X pic Y bandwidth 10g). Regards, Wojciech czw., 29 sie 2019 o 23:40 Jeff Meyers <[email protected]> napisał(a): > Hi Jim, > > thanks for the quick reply! However, unfortunately that did not do the > job and the interface still doesn't show up, neither with 1g nor 10g for > the bandwidth: > > > # show chassis fpc 0 > > pic 0 { > > tunnel-services { > > bandwidth 10g; > > } > > } > > > # show interfaces gr-0/0/0 > > unit 0 { > > description Tunnel; > > tunnel { > > source 1.2.3.4; > > destination 4.3.2.1; > > } > > } > > > # run show interfaces gr-0/0/0 > > error: device gr-0/0/0 not found > > Any ideas? :-( > > > Thanks, > Jeff > > > > Am 29.08.2019 um 12:38 schrieb Jim Alias: > > On DPCs you need to set the bandwidth setting. > > > > set chassis fpc <n> pic <n> tunnel-services bandwidth <10g - 100g> > > > > Be advised that this will burn a 10 gig port for each 10 gigs you assign > to tunnel-services. > > > > Regard, > > Clay Haynes > > > > Sent from my iPhone > > > >> On 29 Aug 2019, at 10:50, Jeff Meyers <[email protected]> wrote: > >> > >> Hi list, > >> > >> I'm trying to setup a GRE tunnel interface on a MX480 with DPCE > >> linecards. I want to use xe-5/4/0 and have therefore configured this > >> interface under 'edit chassis' for tunnel-services. The interface > >> vanishes as expected. I have then configured the interface gr-5/4/0 with > >> unit 0 but is not being created. It's the same behaviour on a secondary > >> MX router so I might be missing something. I am running Junos 13.3 > >> respectively 15.1 on the routers I tested this with. > >> > >> I am unable to identify the reason right now, maybe someone from this > >> list can help me with that? Thanks in advance! > >> > >> Best > >> Jeff > >> _______________________________________________ > >> juniper-nsp mailing list [email protected] > >> https://puck.nether.net/mailman/listinfo/juniper-nsp > > _______________________________________________ > juniper-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/juniper-nsp > _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
