"Alexander Ivanov" <[email protected]> writes: > Device is indeed there: >> lspci -vvvnns 1f.1 >> 00:1f.1 Memory controller [0580]: Intel Corporation Device [8086:9d20] (rev >> 21) >> Subsystem: Gigabyte Technology Co., Ltd Device [1458:1000] >> Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- >> Stepping- SERR- FastB2B- DisINTx- >> Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- >> <MAbort- >SERR- <PERR- INTx- >> Latency: 0 >> Region 0: Memory at 7d000000 (64-bit, non-prefetchable) [size=16M] >> >> >> ps. I misstyped device address in my original post, it is supposed to be >> function 1 not 2: d31:f1. > > gpio-pch depends on X86_32 || MIPS || COMPILE_TEST > > config GPIO_PCH > tristate "Intel EG20T PCH/LAPIS Semiconductor IOH(ML7223/ML7831) GPIO" > depends on X86_32 || MIPS || COMPILE_TEST > select GENERIC_IRQ_CHIP > > the platform at hand, is not X86_32 nor MIPS. It means gpi-pch requires > CONFIG_COMPILE_TEST (to compile drivers which wont load....). Sure enough, > even when driver enumerates, it fails to map BAR: > > [ 105.965846] pci 0000:00:1f.1: [8086:9d20] type 00 class 0x058000 > [ 105.965928] pci 0000:00:1f.1: reg 0x10: [mem 0xfd000000-0xfdffffff 64bit] > [ 105.967084] pci 0000:00:1f.1: BAR 0: assigned [mem 0x7d000000-0x7dffffff > 64bit] > [ 105.978037] pch_gpio 0000:00:1f.1: pch_gpio_probe : pci_iomap FAILED > [ 105.978194] pch_gpio 0000:00:1f.1: pch_gpio_probe Failed returns -12 > [ 105.978317] pch_gpio: probe of 0000:00:1f.1 failed with error -12
This seems to be from an older kernel, but anyway: pch_gpio_probe() attempts to map BAR 1. Your device does not have any such resource. So it fails. > Any suggestions on what driver (if any available) should be used instead? I wouldn't know. But I believe your device looks too different to be compatible with whatever devices this driver was made for. Bjørn _______________________________________________ Kernelnewbies mailing list [email protected] https://lists.kernelnewbies.org/mailman/listinfo/kernelnewbies
