Thanks Maurice, the board edge is actually a footprint, and it was rotated 180° in kicad_pcb file, I don't know if that matters.
About 2), you're right, freecad 0.14 messed up the vrml export. I tried with 0.16 and it looks perfect. I'm on a debian box, the stable freecad version for us is 0.14, in order to get 0.15 I had to compile it, and since it was the same effort as getting the bleeding edge I compiled 0.16. I keep forgetting that gmail's inline images are not shown here, the screenshot in my last mail was this one (thanks Mario) www.paltatech.com/files/offset.png Thanks Marcos On Fri, Aug 14, 2015 at 5:46 AM, easyw <[email protected]> wrote: > Hi Marcos, thank you for the board... > > 1. I had a quick look and I see the position prob... > IDF import in FreeCAD, with this complex edge board, adds a rotation and > probably the center of rotation is not fine ... I' m going to investigate a > bit more if this depend on import or export or on my calculations... > > 2. about the rendering of wrl model SIL7, which version of FC did you use > to export it? > I tried your wrl in kicad and is not well displayed, then I exported the > STEP model to wrl in FC 0.15 and the rendering is fine... > I will post the wrl model when I'll be back home. > > Thank you again for your feedback > > Maurice > > On 14 August 2015 01:59:39 CEST, Marcos Chaparro <[email protected]> > wrote: > >This should work, see attached a test board > > > >[image: Inline image 1] > > > >The SIL7 model is awful, somehow it looks ok in freecad and really bad > >in > >kicad. > > > > > > > >Marcos > > > > -- > Sent from Mobile >
_______________________________________________ Mailing list: https://launchpad.net/~kicad-developers Post to : [email protected] Unsubscribe : https://launchpad.net/~kicad-developers More help : https://help.launchpad.net/ListHelp
