On 04/28/2018 11:25 AM, Rene Pöschl wrote:
On 28/04/18 14:26, jp charras wrote:
you also must set the solder paste ratio clearance clearance to a very
small value (for instance
0.00001 %)
really? so if i set only the solderpaste clearance the global
solderpaste ratio still overwrites my settings? That would be really
strange behavior in my mind.
They are combined so you have to set both of them at the pad level to
ensure any global and/or footprint level settings are not applied.
So what is the minimum for that then? This will affect far more parts
then what the previos problem did because there are quite a few
components that have copper pads with paste margin set but no paste ratio.'''
I don't believe there is a minimum. JP's recommendation should make
virtually no difference in the overall dimensions. It would not be
terribly difficult to calculate.
_______________________________________________
Mailing list: https://launchpad.net/~kicad-developers
Post to : [email protected]
Unsubscribe : https://launchpad.net/~kicad-developers
More help : https://help.launchpad.net/ListHelp
_______________________________________________
Mailing list: https://launchpad.net/~kicad-developers
Post to : [email protected]
Unsubscribe : https://launchpad.net/~kicad-developers
More help : https://help.launchpad.net/ListHelp
