It may be a little silly at first, but put the jumpers into your schematic (which documents them too), then define the jumper footprint as two thru holes. I'm not sure but you might be able to use the same module for all the jumpers of different lenght (if you can edit the pad spacings).
--- In [email protected], "KeepItSimpleStupid" <[EMAIL PROTECTED]> wrote: > > Will 0 ohm resistors work? or Components Like Jx for Jumper Jumper x. > e.g. J1? > > --- In [email protected], "newskyperhh" <boris.fiedler@> > wrote: > > > > Hello. > > > > I want to make a single layer PCB with only one copper site. So i must > > make manually bridges on component side. > > > > But I can't make any pad's or continuous bonding / interlayer > > connection for bridges. > > > > I hope anybody can help. > > > > Thank You, > > > > Boris > > >
