Hello, Gang, I have created gerbers and a drill file from PCB-NEW and I want to create either a GC-PREVUE or TARGET file from them to send to the good people over at PCB-POOL.
In both GC-PREVUE and TARGET, when I import the layers the drill holes show up greatly offset from the gerber layers and flipped along the horizontal axis from the orientation of the gerber layers. Under TARGET, I was very careful to insure the layers were set correctly, but got the same issue. I would bet there is some simple thing I can change to get the gerber and drill file in sync. If any of the gurus here could advise me the best step to take to get everything in sync, it would be most appreciated. Go KiCad! :-) Regards, apluscw
