--- In [email protected], Pedro Martin <[EMAIL PROTECTED]> wrote:
SORTED: I was wiring up wrongly. In protel you can run a wire along a number of component connections, and it links the wire to each device. When I did this in KiCAD, it misses devices. If I place shorter wire segments between each part, it works fine. > > Hi, > Usually this error happens when the wire grid does not match the component's > pins. > See if the pins are on the selected grid or out of it. Then, trace the wire > again. > > Regards, > Pedro. > > > So, it seems I am sometimes placing components, in a way that does not > > connect them, and not 'black square' is created at the interconnect. > > > > What do I do to force the connection? > > >
