Hi, I think you are wrong. This changes the mask clearance around vias and pads. Traces are covered by the mask. It is not possible to set the mask clearance in the module editor since it is not a pad property, but a circuit one. I do not know if it is possible with other programs, with Kicad we only can set one mask clearance for the whole circuit.
Pedro. > If I understand correctly, this only changes the mask clearance around > vias and traces. I need to change the clearance around the pads in > the module editor. > Doug > > --- In [email protected], "bill Randall" <[EMAIL PROTECTED]> > wrote: > > > > Hi, > > I had the same problem - the PCB manufacturer said there was too > much overlap of mask over pad. > > This can be set as follows in PCBNEW: > > Go to Dimensions (top tool bar) > > Go to Tracks and Vias > > Set "Mask clearance" as required (I used 0.004 and PCB manufacturer > is happy with that) > > Bill > > UCT > > > > >>> Pedro Martin <[EMAIL PROTECTED]> 11/11/2008 06:22 PM >>> > > > > Hi, > > > > Dimensions->Tracks and vias -> Mask clearance > > > > Regards, > > Pedro. > > > > > Maybe I missed this in the documentation, but I can't figure out > how to > > > change the solder mask opening size. > > > > > > I am laying out a 4 bump chip scale package and the default mask > opening > > > is too large. How do I change this dimension? > > > > > > Regards, > > > Doug Deeds > > > Forthright Solutions > > > 817 230 4483 > > > > > > > > > > >
